Bosch Sensixx DS37 Instrucciones De Uso página 21

Problem
The appliance
makes a pumping
sound.
Loss of pressure
during ironing.
Water spots appear
on the garment
during ironing.
Water spots appear
on the garment
during use of the
"PulseSteam"
function.
The hose gets hot
during use.
Water leakage from
the boiler.
The iron does not stop
steaming after placing
it on the pad (2).
If the above does not solve the problem, get in touch with our customer service.
All manuals and user guides at all-guides.com
Possible causes
• Water is being pumped into the
steam tank.
• The water tank is not fitted onto the
housing correctly.
• The sound will not stop.
• Steam release button has been
activated for too long a period of
time, that is, it has been pressed
too frequently.
• May be caused by steam
condensed on the ironing board.
• Water spots are caused by steam
condensation in the hose when
cooling down after use.
• This is normal. It is caused by the
steam passing through the hose
during steam ironing.
• Scale collector (18*) located at the
bottom of the appliance is loose.
• "PulseSteam" function has been
activated by double click.
Solution
• This is normal.
• Fit the water tank back onto the hou-
sing correctly (you will hear a click).
• If the sound will not stop, do not use
the steam generator and contact an
authorised technical service centre.
• Use the steam release button at
intervals. This improves the ironing
result as the textiles will be steamed,
dried and ironed properly.
• Wipe the textile cover of the ironing
board, and iron any water drops to dry
them.
• Water drops stop coming out of the
soleplate after using the "PulseSteam"
function for some time.
• Place the hose on the opposite side
so that you cannot touch the hose
during ironing.
Tighten up the scale collector.
• Just press the trigger once again and
the iron will stop steaming at once.
21
BOSCH