off of the buzzer. Once the transmitter code is erased from memory, the buzzer makes a constant 2-second
sound and the LE1 LED stops flashing.
To erase the code of a new transmitter from memory, repeat the operations previously described.
10) HOW TO ERASE ALL TRANSMITTER CODES
To erase all transmitter codes from the control unit memory, press the PL1 key and keep it pressed. The LE1
LED starts flashing and the buzzer makes a slow, 2-second sound. Release the PL1 key and press it within
0.5 seconds. Keep it pressed for 10 seconds at least (during this period of time, the buzzer makes a fast, in-
termittent sound) until the buzzer makes a 2-second, constant sound. At the end, release the push button.
11) HOW TO EXCLUDE AND RESET THE SUN SENSOR IN THE TRANSMITTER
To exclude or reset the operation of the sun sensor, proceed as follows:
- sensor exclusion: simultaneously press the transmitter opening and closing keys;
when the sensor is excludes, the buzzer makes a continuous sound, the red LED switches off and the yellow
LED starts flashing for the entire period in which the sensor is excluded.
- the sensor is reset: press the transmitter opening and closing keys simultaneously ; the buzzer
makes a continuous sound and the yellow LED stops flashing.
12) DISPLAY OF THE LEDs (L1 red, L2 yellow)
Yellow LED on, red LED off
Yellow LED off, red LED on
Red LED flashes
TECHNICAL DATA
Contol unit supply
Operating temperature
Time of work
Output supply
Power maximum motor
Protection level
Radio receiver
All manuals and user guides at all-guides.com
the threshold preset for light has not been overcome. The sun shade cur-
tain will close after 10 minutes.
the threshold preset for light has been overcome. The sun shade curtain
will open after 10 minutes.
a wind or rain alarm has triggered. The control unit sends a closing control
signal to all motors; they can start again for re-opening after 10 minutes.
230 Vac
-10°C / +60°C
2 minutes
1 motor 230 Vac
300W
IP55
433,92 MHz insertable (RR.FWS)