Turn on & Turn o
Turn on
1. Put 1.5V AAA batteries of 2 pcs in the remote
control before using.
2. Press the power switch on the backboard
so that the power light turns red.
3. Press the power key on the remote or
panel, the indicator light will turn green.
4. The lamp will start working 2 seconds later, when an image is
projected on the screen the machine is working smoothly.
5. The new projector may have problems like an unclear image or trapezoid
distortion, Please read "image adjustment" chapter.
6. After you get a clear image, please check the projector and the video
input devices connecting correctly; Press the button "
control or "
" on the control panel to select the signal source to use
S
Signal Source Menu
AV
PC-RGB
HDMI1
HDMI2
USB
Notice:
1. Please select the corresponding input channel when use the HDMI or USB input. For
example, when the U disk plug into the USB 1 interface, you should select the USB 1 as
the signal source.
2. The projector supports the portable hard disk under 500GB (2.5") without external
power; And it is normal that the portable hard disk above 500GB (2.5") cannot be read
and power shortage will be solved by the customer.
Turn o
1. Press the power button when the projector is in use, which will switch to standby
mode.
2. When the projector switch into standby mode, the light will turn green into red.
Signal Source Input Channel
AV input
VGA input
HDMI input 1
HDMI input 2
USB Multimedia input
Video Input devices
DVD players and set top box with AV (RGB)
PC and laptop with VGA interface
Devices with HDMI interface, including PC, laptop, DVD players,
video box, set top box and game console, etc.
U disk or portable hard disk with interface of USB2.0/3.0
13
" on the remote
S