Safety Precautions
Warning:
Please read this manual carefully before use and keep it for future reference.
If operated incorrectly, it will cause electric shock or re. When using or
repairing this projector, please comply with the following points.
1. Read manual
Before using this projector, please read full manual carefully and operate according to
this manual's instructions.
2. Clean
When clean this projector, please pull out the power cable. Use a wet cloth to clean, not
using any detergent that may damage the unit.
3. Accessory
Please use our recommended accessory. Or it will damage the projector.
4. Correct environment
Do not place the projector in a wet environment, like damp basement or near the
swimming pool, etc.
5. Installation
Please place this projector on a stable table.
6. Ventilation
The ventilation is required for the projector to work stably. Do not let the dust wall up
the lter. Or it will cause the projector heating up. Please clean the lter once a month
with some water.
7. Power
Please make sure the power is the same as your projector inquiry speci cation.
8. Earth wire
This projector has an earth wire with a three pin plug.
9. Protect the power cabl
e
Keep the power cable clear of pathways, and do not pull forcefully at any point.
10. Thunder
When there is thunder, or if you will not use the projector for a long time, please unplug
the power cable from the projector.
11. Repair
Due to high voltage inside, please do not open or try to repair the projector by yourself.
Please ask a professional technician to repair the projector.
12. Far away from heat device
Please make sure the projector is far away from any heat devices as it will damage the
projector.
2