Maintenance; Routine Maintenance; General; Lubrication - CAMPAGNOLA C1 Manual De Instrucciones

6

- MAINTENANCE

6.1 Routine maintenance

WARNING!
• Wear a protective mask and direct the air outlet downwards to avoid breathing in noxious vapours.
• Before carrying out any maintenance procedures, disconnect the air supply hose from the tool.
• Any maintenance procedures not dealt with in this manual should be performed at an Authorised CAMPAGNOLA
S.r.l. Service Point.
Routine maintenance work can be performed by operators.

6.1.1 General

Before carrying out any maintenance:
• Engage the safety catch (1).
• Disconnect the air supply hose.
• Wear heavy-duty gloves.

6.1.2 Lubrication

• To keep the necessary lubrication of the pneumatic motor (9), regularly check the oil level in the compressor lubricator.

6.1.3 Greasing the crown wheel and pinion set

• Every 50 working hours remove the screw (21) and check the grease level inside the crown wheel and pinion set. Use only
molibdenum bisulphide of high quality grease to refill.
WARNING!
• Do not use hydraulic oil or brake fluid. These may cause irreparable damage.
• Do not throw the oil out in the environment. Always observe current environmental protection laws when disposing
of the oil.

6.2 Special maintenance

WARNING!
• Before carrying out any maintenance procedures, disconnect the air supply hose from the tool.
• Any maintenance procedures not dealt with in this manual should be performed at an Authorised CAMPAGNOLA
S.r.l. Service Point.
• These operations shall be performed while the tool keeps clamped in a vice. The operator must wear suitable heavy-
duty protecting gloves.
Special maintenance operations must be performed by qualified mechanics.
6.2.1 General
Before carrying out any maintenance:
• Wear heavy-duty gloves.
• Engage the safety catch (1).
• Disconnect the air supply hose.
• Clamp the tool into a vice.

6.2.2 Stalled motor (9)

Pour few diesel drops or spray graphite into the quick air plug (12) in the main handle. Make the tool idle for a while.
If the pneumatic motor (9) does not start running again, take the tool to an Authorised CAMPAGNOLA S.r.l. Service Point.
6.2.3 The crown wheel and pinion set (16) jams
Take the tool to an Authorised CAMPAGNOLA S.r.l. Service Point.
22 - 56