OJ Electronics OCD6-1999 Manual De Instrucciones página 6

OCD6-1999
the pipe must be sealed and the pipe placed as high as possible in
the concrete layer. Alternatively, the sensor can be embedded di-
rectly in the floor. The sensor cable must be led through a separate
conduit or segregated from power cables.
The floor sensor must be centred between loops of heating cable.
The sensor cable may be extended up to 30m by means of a
separate two-core cable. Two vacant wires in a multi-core cable
used, for example, to supply current to the floor heating cable must
not be used. The switching peaks of such current supply lines may
create interference signals that prevent optimum thermostat func-
tion. If a shielded cable is used, the shield must not be connected
to earth (PE). The two-core cable must be placed in a separate
pipe or segregated from power cables in some other way.
Mounting of thermostat with built-in sensor
The room sensor is used for comfort temperature regulation in
rooms. The thermostat should be mounted on the wall approx.
1.5 m above the floor in such a way as to allow free air circulation
around it. Draughts and direct sunlight or other heat sources must
be avoided.
FIG. 4 - OPENING THE THERMOSTAT
1. Slide the power button down to Off "0".
2. Insert a small screwdriver into the central slot of the front cover
to press and hold the catch.
3. Then push the handle of the screwdriver downwards to release
the rear part from the front cover.
4. Carefully pull the rear part away from the front cover, starting
with the lower part of the thermostat.
FIG. 5 - CONNECTIONS
Connect the wires in accordance with the diagram. The wires must
be connected as follows:
Term. 1: Neutral (N)
Term. 2: Live (L)
Term. 3-4: Output, max. 16 A
Term. 5-6: External floor sensor
FIG. 6 + 7 - MOUNTING THE THERMOSTAT
1. Mount the rear part of the thermostat in the wall socket.
8 © 2016 OJ Electronics A/S
English
All manuals and user guides at all-guides.com
OCD6-1999
2. Refit the front cover to the rear part of the thermostat.
Carefully press the cover onto the thermostat, starting with the
upper part of the cover before fitting the lower part of the cover.
3. Click the cover into place by applying light, even pressure.
Warning! Do not apply pressure to the corners of the display
cover or to the display itself.
DO NOT open the thermostat by releasing the four fixing clips on
the back.
FIG. 8 - OPERATING THE THERMOSTAT
There is an ON/OFF switch on the left side of the thermostat: up is
ON - down is OFF.
The resistive touchscreen requires a soft tap with your fingertip to
register the touch.
Installer Wizard:
The first time the thermostat is connected, push the power slide
button to On "I" The Installer Wizard on the touchscreen will guide
you through the set up of:
1. Region
2. Language
3. Date
4. Time
5. Floor Type
Programming
See user manual.
http://www.ojelectronics.com/OCD6
FIG. 9 - TROUBLESHOOTING
If the sensor is disconnected or short-circuited, the heating system
is switched off. The sensor can be checked against the resistance
table.
© 2016 OJ Electronics A/S
English
9