Spare Parts - Hedson IRT 3-1 PcD Manual De Funcionamiento

9.3 Gas pressure spring replacement
If the mobile dryer does not park in highest or lowest
position but falls or raises slightly by itself, tighten the 4
bolts indicated with the letter "C" in fig 2.
If the dryer arm still does not park or becomes heavy to
adjust, the gas pressure spring must be replaced.
Attention!
Due to high weight and complexity it is recommended to
be two persons or one person with a lifting device when
performing this service.
1. Remove the four screws fastening the cover that is
located on either side of the arm (fig 1).
2. Place the parallel arm in the farmost upright position
(fig 2).
3. Before removing the pins holding the gas spring, as
much pressure as possible from the gas spring should
be relieved. To do this, raise the arm slightly until the
pins are loose.
Attention!
At all times when the gas spring is not securely in
position with pins and locking rings, the arm can fall
down heavily from it´s upright position and create
great danger.
4. Remove the locking rings and the two pins. Move the
gas spring slightly upwards/forward and then remove
it (fig 2).
5. Place the new gas spring in the same direction as the
old one. Reassemble in the reversed order.
Attention! Ensure that the locking rings are
refastened properly.
713686 rev 8
Figure1

10. Spare parts

For a complete spare parts list, please contact your
distributor for information. The following spare parts are
the most common ones.
Part
Lamp 1 kW
Filter
Gas pressure spring 850 N (one cassette)
Gas spring 1400 N (two cassettes)
Solid state relay
Fan 12 V DC
C
C
Figure2
EN
Part nr.
102700
713576
714060
713614
750227
711186
C
C
9 9