STAMOS Soldering S-LS-6 Manual De Instrucciones página 13

SETTING THE SOLDERING IRON AND SMD REWORK GUN TEMPERATURE COMPENSATION
Entering into temperature compensation setting mode: when both stations are turned on (switches 5 and 6 turned on),
press simultaneously buttons (11) and (15) for about 3 seconds. Both displays will show "00" and "SOLDERING" and
"HOT AIR" will be flashing. Using buttons (11) and (12) set the desired temperature compensation for soldering iron.
Using buttons (14) and (15) set the desired temperature compensation for SMD rework gun. The range of the compen-
sation is from -50 to +50⁰C. After setting, device will remember entered parameters and starts working after approx. 5
seconds.
If the display is showing the „---„ it means that the output temperature is lower than 100 ⁰C, HOT AIR station is in
GENERAL REMARKS
1.
stand by mode, HOT AIR gun is placed in the holder.
2. If the display is showing "S-E" it means that soldering iron is disconnected, and HOT AIR gun is having problem with
the heat sensor.
3. If the display is showing "F-1" it means that electric circuit of the fan is having problem.
4. If the display is showing "F-2" it means that the fan is blocked.
5. When the device is being turned on, both soldering iron and HOT AIR gun should be placed in their holders.
6. The outlet of the HOT AIR gun should be clean and free from any obstacles.
7. When using small nozzles, it should be remembered that the air flow should be suitable to the diameter of the fixed
nozzle. In order to avoid any HOT AIR gun damages, too high air flow along with the high temperature mustn't be
used for a long period of time.
8. Depending on user's needs, different air flow settings may cause slight variations in temperatures value. The mini-
mum distance between the outlet of the HOT AIR gun and the subject is 2 mm.
9. Good ventilation of the room in which the appliance is used must be provided. In addition, the device should be
placed in a location with good air circulation to dissipate heat.
SAFETY ISSUES REMARKS
1. Nozzles should be installed without the use of excessive force, also do not use the pliers or tweezers. Do not over
tighten the mounting screws of the nozzle.
2. Tips and nozzles can be changed when the HOT AIR gun and the soldering iron are completely cold.
3. It is forbidden to use the device near the flammable or combustible elements and objects or at similar places. Tips
and nozzles as well as the air coming out of the HOT AIR gun have very high temperature, it is forbidden to touch
these elements as well as it is forbidden to put the hot air directly to face or body. This can cause serious burns.
4. After long time of use, the outlet of HOT AIR gun may be covered with some dust. The outlet should be cleaned on
a regular basis in order to ensure undisturbed air flow.
5. Too high temperature of the soldering iron may be the cause of reduction of the functionality of the soldering tips.
6. Soldering iron tip must be cleaned regularly using sponge and plate on a layer of tin to prevent tips oxidation.
EN
13