Troubleshooting - Bticino F500 Instrucciones De Empleo

item F500
INSTALLATION

TROUBLESHOOTING

PROBLEM
The Tuner does not
switch on
The blue backlighting
does not light up when
any of the keys are
pressed
Tuner ON, backlighting
working but no sound
When a station has been
tuned, the green LED
does not light up
When a station has been
tuned, the red LED does
not light up
All manuals and user guides at all-guides.com
No power
Defective tuner
Amplifiers OFF or distant
No 27V d.c. voltage on the
Sound System BUS with
extra power supply
The antenna wire has not
been extended
The signal received is
extremely weak
The Radio Tuner is in a well
shielded room (cellars,
behind heavily reinforced
concrete structures)
The antenna wire has not
been extended
The tuned station does not
transmit in stereo
The signal received is weak
for good stereo reception
The Radio Tuner is in a well
shielded room (cellars,
behind heavily reinforced
concrete structures)
CAUSE
Check the 27V d.c. voltage
on the green terminal
(even if the item is
supplied with cable item
L4668 BUS/60)
Replace
Go to the room where the
amplifiers are and switch
them on
Check the 27V d.c. voltage
on the Sound System BUS
For best reception keep
the antenna wire straight
and if possible vertical
Move the Tuner to an
area covered by the tuned
emitter
Move the Tuner to an
area covered by the tuned
emitter
For better reception keep
the antenna wire straight
and if possible vertical
Move the Tuner to an
area covered by the tuned
emitter
Move the Tuner to an
area covered by the tuned
emitter
40
SOLUTION