Cleaning And Maintenance Instructions; Technical Specifications; Declaration Of Conformity - stayer RF1100 Manual De Instrucciones

4 remains pressed. The tool does not allow interlocking.
• Slowly lower the rear part of the tool to start the groove.
• Slowly move the tool following the drawn path to make
the groove. Use the roll borders as guidance to follow the
desired path.
• Move forward slowly and do not push the tool. Pushing
the tool will damage the tool and won't make the milling
cutter work faster.

5. Cleaning and maintenance instructions

5.1 Maintenance and Cleaning
Before any operation is made, unplug the tool from
the power socket.
Clean the tool with compressed air and a wet cloth.
Every 100 work hours the carbon brushes must be
replaced. The tool is supplied with a set of carbon brushes.
To change them access the brush compartment removing
the two covers with the provided star screwdrive. Slightly
extract the brush support and remove the worn out brush
lifting the string strip first and placing it next to the brush
support (Fig. 2).
Regularly check on the milling cutter's condition. Replace
it when you notice the work is being slowed down. To
sharpen the milling cutter you can use a silicon carbide
grindstone grain 80, but it's best to contact your local
provider.
Replaceable pieces by the user.
Carbon brushes and milling cutters.
Special tools needed.
The tool is supplied with every needed tool.
16. Disposal
We recommend subjecting electric tools, accessories and
packaging to a recovery process that respect the environ-
ment.
Do not throw away electric tools!
For EU countries only:
In accordance with European Directive
2012/19/UE on unserviceable electric and
electronic apparatus, after transposition into
national law, electric tools must be collected
separately to subject them to ecologic recy-
cling.
Subject to change without notice.
ENGLISH
7

Technical specifications

5.3
= Power.
= Speed.
= Max cutting depth
= Cutting width
= Weight.
L = Sound pressure level
pA
L = Sound power level
WA
= Vibrations
= Protection class
The values given are valid for nominal voltages [U]
230/240 V ~ 50/60 Hz - 110/120 V ~ 60Hz. For lower vol-
tage and models for specific countries, these values can
vary. Please observe the article number on the type plate
of your machine. The trade names of the individual machi-
nes may vary.

Declaration of conformity

5.4
EU DECLARATION OF CONFORMITY. The undersigned:
STAYER IBERICA, S.A.
With address at:
Calle Sierra de Cazorla, 7
Área Empresarial Andalucía - Sector 1
28320 PINTO (MADRID)
Tel.: +34 91 691 86 30
We declare under our own responsibility that the product
as describe und "Technical data" is in conformity with the
following standards or standardized documents:
EN 60745-1, EN 15027, EN 55014-1, EN 55014-2,
EN 61000-3-2, EN 61000-3-3 in accordance with the
provisions in Directives 2006/42/CE, 2014/30/EU.
7
Ramiro de la Fuente
General manager
January 2020