3M ST-181 Funcionamiento

π H-2316
3M ST-181 2" PISTOL
®
GRIP DISPENSER
1. Place dispenser on flat surface. Push tape roll fully
onto tape wheel. Be sure tape unwinds with sticky
side down. (See Figure 1)
2. Unroll 5-6 inches of tape (sticky side down) and
thread between smoothing roller and metal loading
gate. (See Figure 2)
3. Pull tape over smoothing roller allowing tape to
unroll freely off tape wheel. (See Figure 3) To adjust
tension, see Figure 4.
4. Start at desired depth on side of box. (See Figure 5)
5. Pull dispenser along the carton seam - smoothing
roller automatically presses tape to the package.
(See Figure 5)
Figure 1
Figure 4
PAGE 1 OF 3
1-800-295-5510
uline.com
OPERATION
6. Continue down the opposite end to desired length.
In one motion, tilt dispenser forward so tape pressing
wiper stops rolling tape, serrated blade cuts tape
and wiper smooths the tape end. (See Figure 6)
Figure 2
Figure 5
START
HERE
Pour le français, consulter la page 3.
Pressing Wiper
Smoothing Roller
Cutting Blade
Adhesive Side
of Tape Down
Metal
Loading Gate
Figure 3
Figure 6
Para Español, vea página 2.
Tension Knob
1020 IH-2316