Installing The Switch On A Wall - Dell PowerConnect PC2216 Guia De Inicio Rapido

Figure 1-1. Brackets for Rack Installation

Installing the Switch on a Wall

To mount the switch on a wall, complete the following steps:
1
Ensure that the mounting point meets the following requirements:
• The wall surface must be capable of supporting the switch.
• Allow at least 5.1 cm (2 inches) on each side for proper ventilation and 12.7 cm (5 inches) at the back for power
cable clearance.
• The location must not be located in direct sunlight.
• The location must not be within 2 feet of any heating vents, nor should any area heating vent point toward
the unit.
• The location must be ventilated to prevent heat buildup.
• Do not locate the switch where there may be data or electrical cabling located directly behind the unit.
• The power cable must reach an outlet.
2
Use the supplied screws to attach a mounting bracket to each side of the switch (see Figure 1-2).
3
Place the switch against the wall and mark the wall through the holes of the brackets.
4
Drill holes in the wall for the brackets and install the appropriate mounting hardware (not supplied).
5
Place the switch against the wall so that the bracket holes align with the holes in the wall.
6
Insert and tighten the screws through each of the mounting brackets.
4
Getting Started Guide
All manuals and user guides at all-guides.com