Uline H-7899 Manual Del Usuario página 2

1. Remove and unpack all pieces from the carton.
2. Attach base tube to base by inserting base tube
through under side of base and attach using two
M5 x 20 hex socket head screws. (See Figure 1)
Figure 1
3. Lay base down with corner plates touching floor.
4. Attach two non-locking and two locking casters to
corner plates using one M10 hex nut, one M10 spring
washer and one M10 washer per caster.
(See Figure 2)
NOTE: Lock casters for the remainder of the
assembly process.
Figure 2
PAGE 2 OF 12
ASSEMBLY
5. Align holes on corner plates of upright frame with
holes on base. Use three M10 x 70 hex bolts, three
M10 hex nuts, three M10 spring washers and three
M10 washers to attach each corner plate of upright
frame to base. (See Figure 3)
Figure 3
6. Attach support bar to top center of upright frame
using one M10 x 110 hex bolt, one M10 wing nut, one
M10 spring washer and one M10 washer.
(See Figure 4)
Figure 4
0621 IH-7899