Sound Mode; Dmx-512 Connection; Dmx Channels - Beamz Magic Jelly Manual De Instrucciones

C. SOUND MODE
Press the MENU button till S1_x or S2_x is shown in the display
S1_x and S2_x are 2 different sound programmes.
With music applied the last number will count up from 0 till 20. These are the steps of the sound programmes.
Press ENTER to confirm and save these settings.

DMX-512 CONNECTION

If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5-pin DMX connection, you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal
(+) into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.

DMX CHANNELS

Channel Function
1 Strobe
2 Red
3
Green
4 Blue
5 Rotation
6 Mode
FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding
can cause greater accumulation of dirt on the unit's optics.

Make sure the area below the installation place is free from unwanted persons during servicing

Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any deformation

The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is
detected

In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned
monthly.

The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.

Clean with soft cloth using normal glass cleaning fluid.

Always dry the parts carefully.

Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!
All manuals and user guides at all-guides.com
Value Description
000-004 No function
005-255 LED Strobe (from slow to fast)
000-255 Dimming 0-100%
000-255
Dimming 0-100%
000-255
Dimming 0-100%
000-127 Forwards
127-255 Backwards
000-010
No function
011-233 Auto mode
234-255

Sound mode

5