Battery Installation - Affinity iLumaLight El Manual Del Propietario

BATTERY INSTALLATION

1
1
2
Open battery case by squeezing
both ends of the cover inward and
lifting to release.
IMPORTANT NOTE:
Installing the battery backwards
will prevent the product from
functioning and may damage it.
Align +/- markings on battery
with printed circuit board.
ALWAYS start with a NEW
battery. One (1) Alkaline 1.5V
C-cell is required (not included).
1
For product information and videos visit:
www.AffinitySeats.com
2
+
Install a new C-cell battery matching
the + and - markings. When inserted
properly, the red LED light will turn
on for a few seconds and indicate
the battery is installed properly.
3
Replace cover. Make sure rubber
gasket o-ring aligns with groove.
Make sure the photo sensor lens
cover is above the photo sensor.
–
3