Evolve ShowerStart TSV EV3332-CP150 Manual Del Usuario página 12

5
Cut the water supply pipe at the
mark.
½" Galvanized
½" Copper
11
Slide the correct Seal over the water supply
pipe until it touches the Slip-Fit Quick Connect
Back Plate. The small end of either seal
should be facing outwards.
6
Place the Registration Plate against the wall
so the water supply pipe fits within its notch.
Adjust so its alignment indicator is vertical.
12
Slide the Slip-Fit Quick Connect Receiver
over the water supply pipe until it is seated
upon the Seal.