Cabinet Preparation For Hoods Support; Preparing Electrical Connections - Haier HHX1030 Manual Del Usuario

All manuals and user guides at all-guides.com
For model HHX1030 you must remove the vent cover from the slots on the front of
the range hood. Save the vent cover for possible future use.
Cabinet Preparation for Hood Support
Mount the hood so that the bottom of the hood is between 24"-30" above the
stovetop.
Warning! When cutting or drilling into wall or cabinet, be careful not to cut
existing electrical wiring.
1. If the bottom of the cabinet is recessed above the bottom of the cabinet
door, then it is necessary to install wood strips on each side of the
recessed area on the bottom of the cabinet where the range hood will
be mounted. The wood strips should line up with the 4 keyhole slots on
the top of the range hood. Fasten the wood strips with wood screws
about 3" in from each end.
Note: The thickness of the wood strips should be slightly more than the
recessed dimension. The length should be cut to size.
2. Measure and mark the electrical wiring opening in the wall or the
cabinet. If the hood is to be vented, also mark and measure the duct
opening in the wall or cabinet.
Preparation of Electrical Connections
Note: If replacing an existing hood, the electrical cable may need to be re-routed to
the desired position.
1. Determine the location of the electrical cable to connect to the range
hood.
English
fig. 1
6