Perel LEDA3001 Serie Manual Del Usuario página 6

LEDA3001xx-x/3002xx-x/3003xx-x/3005xx-x
2. Use the mounting bracket [1] to determine the location of the
mounting holes.
3. Drill the holes and secure the bracket using screws and wall
plugs.
4. Connect the power cable to a suitable junction box (not incl.).
Make sure the connection is properly earthed. Make sure there is
no strain on the cable; leave sufficient slack.
Warning: if the power cable is damaged, it must be replaced by the
manufacturer, his service agent, or a similar qualified person in order
to avoid any hazard.
5. To point the lamp in the desired direction: loosen the hinges [2]
using a spanner.
6. Tilt the lamp in the desired angle and tighten the hinges.
7. Cleaning and maintenance
 All screws should be tight and free of corrosion.
 The housing, the visible parts, the mounting supports and the
installation location (e.g. ceiling, suspension, trussing) should not
be deformed, modified or tampered with; e.g. do not drill extra
holes in mounting supports, do not change the location of the
connections...
 Mechanically moving parts must not show any signs of wear and
tear.
 The electric power supply cables must not show any damage.
Have a qualified technician maintain the device.
V. 02 – 25/02/2015
N = neutral, blue
E = earth, yellow/green
L = line, brown
6 ©Velleman nv