Storing The Device When Not In Use; Troubleshooting - Crivit CEK 29 A1 Manual De Instrucciones

Crivit CEK 29 A1
After cleaning, insert the lid [2] again by bringing it into an upright position to the cool box. Now
first insert the lid [2] into the left opening and then press it into the right recess [10].

9. Storing the device when not in use

If you do not want to use the cool box for a long period of time, please remove all items from the
cool box. Disconnect the cool box from the mains and store the connecting cables in the cable
boxes [3], [4]. Make sure that the cool box is stored in a clean, dry place away from direct
sunlight. Allow the lid [2] to stay open when storing the cool box to ensure good ventilation. The lid
[2] can be fixed open using the locking mechanism [9].

10. Troubleshooting

The cool box doesn't seem to be working
 Check whether the cigarette lighter socket connection [1] is plugged into the cigarette lighter
socket correctly or the plug [8] is correctly inserted into the power socket.
 In 12 V mode: Turn on the ignition of your vehicle, as some vehicles will only power the
cigarette lighter socket when the ignition is on.
 In 12 V mode: The fuse is faulty. Change the fuse: When doing so, refer to Section "8.2.
Replacing the 12 V fuse".
The cool box is not chilling properly
 Place the cool box in a cooler place. When doing so, make sure that the cool box is not
exposed to direct sunlight.
 Ensure that the ventilation slots are not covered and a sufficient amount of air is able to
circulate.
 In 230 V mode: Check the position of the output controller [7] on the front of the cool box and
turn this clockwise to increase the output if necessary.
The cool box is not warming properly
 Ensure that the ventilation slots are not covered and a sufficient amount of air is able to
circulate.
 In 230 V mode: Check the position of the output controller [7] on the front of the cool box and
turn this clockwise to increase the output if necessary.
60 - English