West Marine BilgePro Auto 600 Manual Del Usuario página 3

Model 7865603 BilgePro™ Auto 600
Model 7865611 BilgePro™ Auto 800
Model 7865629 BilgePro™ Auto 1000
12V submersible bilge pumps for pumping bilge water in marine
environments. To be installed in the keelson.
Security
• The pump may not be used for liquids other than water/bilge water.
• Always install the pump according to the wiring diagram, see
pages 13-14.
• Always use the fuse required, see "Specifications" below.
• The wire connections must be sealed with a marine sealant.
• Insulation or cable sheathings must be placed above the highest bilge
water level.
• Do not run dry.
Operation
See illustration page 12
1. When the bilge water rises and reaches the second detector cell at
2" (51mm) the switch starts the pump, with a 3 second delay.
2. When the water level has sunk to a level of 3/4" (19mm), and the first
detector cell is above the water level, the pump is stopped.
Specifications
Hose size
Capacity,
w/o check valve 630 gph (2384 Lph) 800 gph (3027 Lph) 1000 gph (3784 Lph)
Capacity,
w/check valve
Voltage
Amperage
Fuse size
Body
Shaft
Shaft seal
Wire size
Max height
Max dia.
Weight
gePumpAuto_600-1000.indd 3
600 800
3/4" (19mm) 3/4" (19mm)
600 gph (2270 Lph) 750 gph (2838 Lph) 900 gph (3405 Lph)
12V DC 12V DC
2.5A 3A
5A 5A
Thermoplastic Thermoplastic
316 Stainless Steel 316 Stainless Steel
Lip seal Lip seal
16 GA (1.5mm) 16 GA (1.5mm)
4-1/2" (112mm) 4-1/2" (112mm)
2-3/4" (70mm) 2-3/4" (70mm)
14 oz. (0.4kg) 16 oz. (0.45kg)
English
1000
3/4" (19mm)
12V DC
3.2A
5A
Thermoplastic
316 Stainless Steel
Lip seal
16 GA (1.5mm)
4-1/2" (112mm)
2-3/4" (70mm)
16 oz. (0.45kg)
2/16/06 12:22:30 A