Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
To remove or replace the power cartridge
See page 15
1. Lift tab and rotate the two fins in a counter clockwise direction and
lift out.
2. To reinstall, first make sure that the seal is properly located. Coat the
seal with a light film of vegetable oil or mineral oil, then align the two
cams on either side of the power cartridge with the two slots in the outer
housing. Press down and twist in a clockwise rotation. To ensure that
the power cartridge is properly located, twist fins in a counterclockwise
direction without lifting tab. Cartridge should stay in place.
Accessories
(Always install according to the wiring diagram on pages 13-14.)
Model 543546 BilgePro Auto 3-Way Panel Switch
gePumpAuto_600-1000.indd 5
English
2/16/06 12:22:31 A
Publicidad
Tabla de contenido
