To Un-Pair The Pulse - Antec Mobile Products Pulse Manual Del Usuario

All manuals and user guides at all-guides.com

To Un-pair the pulse

There are two ways to un-pair, or disconnect the pulse from the Bluetooth device. First, you can
disconnect the pulse from paired mode by simply disabling the connection using the Bluetooth
settings in your audio device. Or you can cancel the connection by pressing and holding the pulse's
Volume up & Backward button for 3 seconds.
"Passive Mode"- Connecting using the 3.5mm or USB cable
If you don't have a Bluetooth-enabled device or simply do not want to use the pulse in pair mode,
you can still connect the pulse to your audio device using cables-just as you would with normal
headphones. To do so, simply connect the pulse to your device using the included 3.5mms stereo
input cable. Actually, this is method recommended, as it will save battery charge and still provide
the same listening experience. We highly recommend you can use this mode when traveling on the
aircraft. Absolutely, we have already prepared the Airline adapter for you in the box.
Using the pulse mobile phone functions:
With its integrated microphone, the pulse also supports full mobile phone functions. By using the
controls you can pick up and place calls and switch between mobile phone and audio functions.
To toggle between audio headset and cellular phone settings, simply press and hold the PHONE
button on the side of the pulse. Then use your mobile phone as you normally would to make your
call. When receiving an incoming call, the pulse will emit the incoming tone to alert you. Pick up the
call by pressing the PHONE button once. If you don't want to be bothered, just press and hold the
PHONE button to reject the call. During the call you can use the Vol+ or Vol- to adjust volume or
mute the caller. If your mobile device has a hands free function or supports voice dial then you can
use the pulse to perform those actions.
EN