KPS PW300 Manual De Instrucciones página 2

INSTRUCTIONS MANUAL
Digital Clamp Meter
KPS-PW300
Cod: 602150038
SKU: KPSPW300CBINT
Digital multimeter
ENGLISH
GENERAL DESCRIPTION
The 3-phase clamp-type digital power meter is a handheld intelligent harmonic power tester,
with both functions of digital current testing and power testing. The tester is comprised of three
channels including voltage, current, and power as well as a micro single chip system, and it
is equipped with a powerful software for measurement and data processing functions; it can
measure, calculate, and display voltage, current, active power, power factor, apparent
power, passive power, frequency, harmonic parameters, with stable performance and
operation convenience. The meter is especially suitable for the measurement and
examination of on-site power equipment and power-supplying circuits; with hand-held
clamp structure, small volume, and lightweight, it can be easily carried by the user, which
makes it easy and fast for doing measurement. The meter is your ideal choice for
measurement of single-phase/ three-phase power.
SAFETY INSTRUCTIONS
The three-phase clamp-type digital power meter is designed and manufactured in
accordance with international standard, IEC61010-1, and international safety specifi cation,
IEC1010-2-032, and the meter strictly follows the safety standard of double-insulation AC
600 V CAT III.
SAFETY REQUIREMENTS
Please carefully read the instruction manual before using the tester, and pay
special attention to "Warning" content. Please follow instructions under "Warning".
1. Please be very careful when test voltage is higher than AC 30 V, and do keep in
mind that your fi nger shall not exceed the hand-shielding part of the test probe.
2. Do not measure voltage which is higher than the allowed input limit.
3. Before use, please check the meter and test probe; do not carry out testing in
case the test probe is naked, tester housing is damaged, or there is no LCD
display, etc..
4. It meets requirements of safety standards only when the meter is used together
with the supplied test probes. In case the test probe is damaged and needs
replacement, it is required to replace it with a test probe of the same model and
identical electrical specifi cations.
5. Please never carry out any voltage measurement whenever the test probe is
inserted in any current outlet.
6. Please do not expose the meter to strong light, high temperature, or dampness.
WARNING
Before use, please carefully read this instruction manual. Especially safety
contents!
REPLACING TEST LEADS
Replace test leads if leads become damaged or worn.
WARNING
Use meet EN 61010-031 standard, rated CAT III 600V, or better test leads.
REPLACING THE BATTERIES
WARNING
To avoid electric shock, make sure that the test leads have been clearly
move away from the circuit under measurement before opening the battery
cover of the meter.
WARNING
Do not mix old and new batteries. Do not mix alkaline, standard (carbon-
zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.
1. If the sign " " appears, it means that the batteries should be replaced.
2. Loosen the fi xing screw of the battery cover and remove it.
3. Replace the exhausted batteries with new ones.
4. Put the battery cover back and fi x it again to its origin form.
Note: Do not reverse the polarity of the batteries.
EN
ACCESSORIES
Item
Short Instruction manual
1.5V AA Baterry
Test probe
Test clip
Interface cable
PC Software CD
Package box
instruction manual:
APAC: MGL GLOBAL SOLUTIONS LTD
info.apac@mgl-intl.com
Flat 4-1, 4/F, No. 35, Section 3 Minquan
East Road. Taipei, Taiwan.
Tel: +886 2-2508-0877
EMEA: MGL EUMAN S.L.
info.emea@mgl-intl.com
Parque Empresarial Argame, 33163
Morcín. Asturias, Spain.
Tel: +34 985-08-18-70
Digital Clamp Meter
Quantity
1
4
1
3
1
1
1
See the full
AMERICAS: MGL AMERICA, LLC.
info.na@mgl-intl.com
US East Coast: 2810 Coliseum Centre
Drive, Ste. 100. Charlotte, North Carolina,
28217 USA
Tel: +1 833 533-5899
US West Coast: 760 Challenger Street.
MGL EUMAN, S.L.
Brea, California 92821 USA
Parque Empresarial de Argame,
Tel: +1 310-728-6220
C/Picu Castiellu, Parcelas i-1 a i-4
E-33163 Argame, Morcín
www.mgl-intl.com
Asturias, España, (Spain)