Troubleshooting - Ribimex Ribiland PREHLS52 Manual De Instrucciones

6.4- Troubleshooting

PROBLEM
Falls to split logs
The log pusher moves
jerkily, taking unfamiliar
noise or vibrating a lot
Oil leaks around cylinder
ram or from other points.
Motor does not start
Log Splitter does not
work while motor
running
6.5- Storage
Product must be stored in a dry location.
Always lock up product and keep out of reach of children
PROBABLE CAUSE
Log is Improperly positioned
The sizes or hardness of the log.
exceeds the capacity of the
hi
Wedge cutting edge is blunt
Oil leaks
Unauthorized adjustment was
made on Max.
Limiting Screw. Lower max
pressure rating was set.
Lack of hydraulic oil and
excessive air in the hydraulic
system.
Air sealed in hydraulic
system while operating.
Bleed Screw is not tightened
before moving the
splitter.
Oil Drain Bolt
Dipstick is not tight.
Hydraulic Control
Assembly and / or seal(s) worn
No current in the socket
Electrical extension
defective
Switch or capacitor defective.
Valve is not opened owing to the
connection parts loosening
Control Levers or Connection
parts bent.
Lower hydraulic oil level
REMEDY SUGGESTED
Refer to" Log Splitter Operation"
section for perfect log loading.
Reduce the log sizes before splitting it
on the log splitter
Refer to" Sharpening the Wedge"
section to sharpen the cutting edge.
Locate leak(s) and contact the dealer
Contact the dealer.
Pressure
Check oil level for possible oil
refilling. Contact the dealer.
Loosen Bleed Screw by 3~4 rotations
before operating the log splitter
Tighten the Bleed Screw up before
log moving the log splitter.
with Tighten the Oil Drain Bolt with Dipstick.
Valve Contact the dealer
Check mains fuse
line Unplug, Check and replace.
Have checked by Electrician
Check and tighten the parts.
Repair the bent parts
Check and refill hydraulic oil.