Gude GDB 24V/12V-200 Traducción Del Manual De Instrucciones Original página 24

ENGLISH
20
ANALYSING 1
STEP 1
DESULPHATION
STEP 2
SOFT START
STEP 3
CONTROLLED CURRENT CHARGE
STEP 4
STEP 5 ANALYSING 2
STEP 6 CONSTANT OUTPUT CHARGE
RECOVER CYCLE CHARGE
STEP 7
ABSORBTION
STEP 8
ANALYZING 3
STEP 9
MAINTENANCE
STEP 10
E01 + ERROR LED LIT
E02 + ERROR LED LIT
E03 + ERROR LED LIT
E04 + ERROR LED LIT
REPAIR ON DISPLAY + REPAIR
LED FLASHING
REPAIR ON DISPLAY + REPAIR
LED SOLID LIT
The battery charger adapts the charging line itself
reverse connection
temperature in charger is too high
the battery cannot store electric charge / dead battery
no battery connected / battery voltage is lower than 1 volt / dead voltage
charger automatically enters repairing mode
manually choose repairing mode
Checks if battery has connected with the charger
Pulsing charging to remove sulfate
Charges with gradually increasing charging current
Adjusts the charging current intelligently
Tests if the battery can absorb charge
Charges with constant voltage and compensates fake full charge
caused by high current charging
Absorbs morge charge and compensates side effect of recuces
charging current
Charges with constant trickle current for maximum battery voltage
Tests if the battery can hold charge
Continuously monitors the battery, and charges with trickle current
once the voltage is lower than threshold
ERROR CODES
+
-