Maintenance - Greencut SRJ200L Manual De Instrucciones

PENDULUM ACTION
The pendulum action can be adjusted using the pendulum knob located on the left side of the jigsaw, next to the
blade. There are four settings marked: 0, 1, 2 and 3. The best pendulum stroke settings for a given job are shown
below:

MAINTENANCE

Good maintenance extends the life of the machine. Prolonged or constant use may require more intensive maintenance
to keep the machine running smoothly.
• Never use excessive force when cutting. Excessive pressure reduces the speed of the machine and the power
required is greatly reduced. This can cause an overload that may damage the machine's motor.
• If the machine becomes too hot, let it idle for two minutes, then stop working for a short time. Clean the
machine with a clean cloth and brush. Make sure that the ventilation slots are not blocked.
• Never use water or other liquids to clean the electrical parts of the tool. Always clean the tool after use.
• Make sure that the ventilation slots are not blocked to prevent overheating.
• Check the carbon brushes regularly (dirty or worn carbon brushes cause excessive sparking and loss of
speed). This should only be done by an official service centre.
• Always replace carbon brushes in pairs.
• During servicing, use only the manufacturer's original spare parts, accessories and supplements. The use of
any other parts may create a hazard or damage the product.
WARNING: Ensure that the machine is completely switched off before carrying out any maintenance
or repairs. This will eliminate any potential hazard.
WARNING: Clean the machine after each use to prevent the build-up of sawdust and wood resin
on the machine components, table and saw blade. Before maintenance and cleaning, make sure
the battery is disconnected from the saw. Use only mild soap and a slightly damp cloth to clean your
saw. Many household cleaners contain chemicals that could seriously damage the plastic. Do not
use petrol, turpentine, lacquer, paint thinner or similar products to clean the machine. Never allow
any liquid to enter the tool or immerse any part of your saw in any liquid.
Chapa
Steel
Plywood
Aluminium
Plastic
Wood
0
0
2-3
0
1-2
2-3
53
EN