Control Box; Main Switch - Uline H-9272 Manual De Instrucciones

SAFETY FLAP
It may be necessary to use foot to assist in tilting
back loaded powered stair climber. Use swing arm,
main wheel or lower portion of drive unit. Safety flap
prevents foot from getting jammed under swing arm by
automatically ceasing all operation when depressed.
To resume use, release safety flap and press
round-up switch. (See Figure 1)
CAUTION! Only turn main battery switch on
after tilting the load.
Figure 1
Safety Flap
Swing Arm

MAIN SWITCH

Main switch is located on battery cover and is used to
turn power supply on and off. (See Figure 2)
Figure 2
Snap on
Battery
Power can be shut off by doing one of the following:
• Turning main switch off on battery unit.
• Removing battery.
• Pressing ascend/descend button for three seconds
or longer.
NOTE: Power shuts off automatically after
10 minutes of non-use.
PAGE 2 OF 18
CONTROLS

CONTROL BOX

INDICATOR LIGHT
• Constant Green: Unit is in ascend mode and
• Flashing Green: Unit is in descend mode and
• Constant Red: Unit is in descend mode and support
• Flashing Red: Unit is overloaded and indicator light
Drive Unit
• Alternating Flashing Green/Red: Battery charge is
Main
Wheel
SPEED SWITCH
In ascend mode, choose
Main
speed (See Figure 4):
Switch
•
•
In descend mode, speed is set and cannot be adjusted.
ASCEND/DESCEND BUTTON
• Briefly press to switch unit to ascend or descend
round-up switch in upper handle is active. Lifting
mechanism operates when round-up switch is
depressed and stops when released. (See Figure 3)
round-up switch is inactive.
wheels move quickly to descend position.
will flash for three seconds and shut off.
low.
Figure 3
Indicator Light
Speed
Switch
Control
Box
Low speed – one line
High speed – two lines
NOTE: Low speed is advisable for training,
heavy loads and awkward locations.
mode. (See Figure 3)
NOTE: Unit will switch off if button is pressed for
three seconds or longer.
Ascend/Descend
Button
Figure 4
Low Speed
High Speed
0321 IH-9272