Master Gym E383 Manual Del Usuario página 6

ASSEMBLY INSTRUCTIONS
Lower Part Assembly
1. Remove the bolts from the support tubes (2 and 2A) and insert the
steel bar. Fix them with the same bolts previously removed.
2 Insert the frame (1) into the rear support end (2). Repeat the
procedure with the opposite end and adjust it with the bolts (12) and
lock washers (18) use both, the open end wrench and the Allen
wrench.
Note: Make sure the loop for the stretching rubber bands is facing
outwards.
All manuals and user guides at all-guides.com
3. Insert the swing tubes (4) into the frame (1) (one end at a time) and
tight them using bolts (13) and lock washers (18) (2 per bolt), hold it
with the Allen wrench and tighten with the open end wrench. Repeat
the procedure with the opposite end.
4. Place the non-slip pedal (13) on the backpedal (5) and introduce the
hexagonal screws (16) from top to bottom. Fix them with the nuts (19)
and lock washers (18) with the open end wrench. Repeat the
procedure with the other non-slip pedal.