Standby Mode; Frequently Asked Questions - Marmitek INVISIBLE CONTROL BLACK 4 Manual Del Usuario

5. STANDBY MODE

The Invisible Control can be connected to the mains or can work using just a battery. If
you are inserting a battery, the Invisible Control will automatically switch to stand-by
mode after 4 hours, to conserve energy. You can activate the Invisible Control by press-
ing a button on your remote control within 50 cm of the receiver. A red light will ash
to con rm the receiver is ready for use. After reactivation, the Invisible Control can
receive all signals from the remote control within a distance of 4 to 8 m, under an angle
of 30°. The Invisible Control will switch to stand-by mode when it has not been used for
4 hours.
If you have connected the Invisible Control to the mains, it will remain switched on. You
do not need to activate the Invisible Control with your remote control rst.

6. FREQUENTLY ASKED QUESTIONS

• In a few cases, the Receiver may be disrupted by interference and cannot, therefore,
pick up the signals it receives. If this is the case the red light will be continuously illu-
minated than the Receiver must be relocated. This interference is caused by equip-
ment in the vicinity such as dimmers, energy-saving light bulbs, IR alarms and so on.
Direct sunlight can also disrupt the Receiver.
• Invisible Control does not work with remote controls which use High Frequency sig-
nals (such as B&O).
• Please ensure that the LEDs of the IR extender cable are placed correctly to the
infrared sensor of the A/V device, this has to be done very precisely. The exact posi-
tion can be found easily by shining at it with a ashlight.
• Some IR windows from set-top and satellite boxes are very sensitive and are easily
disrupted. These devices then receive too much infrared light and will either work
badly or not work at all. Relocate the IR LED so that less infrared light is received via
the IR window.
Do you have other questions that have not been resolved by the above information?
Please go to www.marmitek.com
INVISIBLE CONTROL BLACK/WHITE 4 5