Maintenance/Cleaning; Troubleshooting - LIVARNO LSLB 24 B1 Manual De Instrucciones E Indicaciones De Seguridad

LIVARNO home LSLB 24 B1

8. Maintenance/cleaning

Maintenance
The LED spotlight (1) does not contain any components that require maintenance. The LED lamp cannot be
replaced.
The light source of this light cannot be replaced. You need to replace the entire light when the light source
has reached the end of its service life.
Cleaning
DANGER! The electric circuit must be switched off during any work on the LED spotlight (1)
and also during cleaning! There is a risk of electric shock!
DANGER! Ensure that no liquids enter the housing of the LED spotlight (1) There is a risk of
electric shock.
Clean the LED spotlight (1) using a soft, dry cloth, and never use cleaning agents or solvents that react
with plastic. Only use a very slightly moistened cloth in case of heavy soiling.

9. Troubleshooting

The light does not go on
 The motion sensor (2) is not properly aligned. Correct its alignment.
 The electrical connection is faulty. Have the electrical connection checked by a qualified electrician.
The light goes on and off in rapid succession
 The sensor is experiencing interference caused by an external light source or bright, reflecting
surfaces. Remove the external light source or the surfaces that cause interference.
The light does not go off
 There are persons or objects in the sensor range of the motion sensor (2). Remove these.
 The LED spotlight (1) is swaying in the wind, causing the motion sensor (2) to trigger continuously.
Make sure the LED spotlight (1) is firmly attached to a sturdy surface.
30 - English