Sebson SC BODY FAT B Manual Del Usuario página 13

Measure weight:
1. Place the device on a firm, vibration-free and level surface. Please make sure that all 4 leveling feet of the
balance touch the floor.
2. If possible, stand in the middle of the scale. Do not stand on the display! Attention: If you stand on the
edge of the scale, the scale may tilt to the side. There is a risk of injury!
3. The scale is now activated and measures your weight.
4. During the measurement, hold as still as possible to avoid measuring errors.
5. The measurement is finished as soon as the weight display starts flashing.
6. Automatic switch-off function: After approx. 8 seconds of inactivity, the device switches itself off
automatically.
Store personal data for body analysis:
In order to determine, for example, the percentage of body fat or body water of a person with this device,
information such as age, sex and height of this person must first be entered into the device. Up to 8 persons can be
stored. To do this, please proceed as described:
1. Press SET-key
2. Select "User" with the
3. Select gender
4. Select "Age" with the
5. Select "Height" with the
Perform body analysis:
It is recommended to always perform the body analysis at the same time of day with the water balance remaining
as constant as possible (e.g. in the morning after the first visit to the toilet). Wear no or only very light clothing
during the measurement. Note: The body analysis can only be carried out barefoot and only standing up! Please
enter the scale with clean and dry feet!
The values are determined as described:
1. Place the device on a firm, vibration-free and level surface. Please make sure that all 4 leveling feet of the
balance touch the floor.
2. Press SET-key
3. Select "User" with the
4. Confirm gender
5. Confirm "Age" with "SET".
6. Confirm "Height" with "SET".
7. As soon as "0.0" appears in the display, the measurement can be started.
8. Place yourself on the metal surfaces of the balance with your legs as straight as possible. Your knees must
not touch during the measurement. Stand as still as possible during the measurement.
9. Your weight is shown on the display first. Stay still on the scale. The weight display will stop flashing after a
few seconds. Then the other values such as the percentage of body fat etc. are determined. This is
indicated on the display by the following symbol:
10. After a successful measurement, the following values are displayed one after the other below the weight
display in the following sequence: BMI → body fat content → body water content → muscle mass content
→ bone mass content → calorie requirement → visceral fat content
11. Then exit the balance. The measured values are displayed three times in succession. The balance then
switches itself off automatically. The values are saved.
keys and confirm with "SET".
and
keys and confirm with "SET".
with the and
keys and confirm with "SET".
and
keys and confirm with "SET".
and
keys and confirm with "SET".
and
with "SET".
. Continue to stand still on the scale.
13