Rampage Cowl Light Mount Instrucciones De Instalación página 2

2
Place Large Spacers in top bolt recesses with
foam side down.
See Figure 2
3
Locate Driver/Left Cowl Light Mount. Place (1)
8mm Allen Bolt with 8mm flat washer through
rear side mounting hole.
Place (1) Small Spacer on bolt with foam side
away from bracket.
Bolt assembly to the rear side mounting hole in
the cowl.
See Figure 3
4
Place (1) 8mm Allen bolt with 8mm flat washer
through from side mounting hole.
Place (1) Small Spacer on bolt with foam side
away from bracket.
Line up bolt with appropriate hole in Cowl Panel
and hand tighten bolt. Do not fully tighten at this
time.
See Figure 4
5
Install 6mm Allen Bolts with 6mm flat washers at top
mounting holes, through the Large Spacers and
into the body. Leave hand tight.
See Figure 5
Figure 2
Figure 3
Figure 4
Figure 5
Page 2 of 3