Working Safely - Festo TP700 EduTrainer Manual De Instrucciones

The Touch Panel EduTrainer

For its intended purpose

When its safety functions are in perfect condition
Malfunctions which may impair safety must be eliminated immediately!

4.5 Working safely

General information

Trainees should only work with the circuits under the supervision of a trainer.

Electrical devices (e.g. power supply units, compressors and hydraulic power units) may only be
operated in training rooms which are equipped with residual current devices (RCDs).

Observe the specifications included in the technical data for the individual components, and in
particular all safety instructions!

Malfunctions which might impair safety must not be generated when the device is operated for training
purposes.

Wear personal safety equipment (safety goggles, safety shoes) when working on circuits.
Electrical data

Risk of death in case of interrupted protective earth conductor!
– The protective conductor (yellow-green) must not be interrupted, either inside or
outside of the device.
– The insulation of the protective conductor must never be damaged or removed.

Risk of death from connecting power supply units in series!
Contact voltages of greater than 25 V AC or 60 V DC are not permissible.
Coming into contact with voltages of greater than 50 V AC or 120 V DC may be fatal.
– Do not connect voltage sources in series.

Risk of death due to electric shock!
Protect the outputs of the power supply units (output sockets/terminals) and cables connected to them
from direct contact.
– Only use cables with adequate insulation and electric strength.
– Use safety sockets with fully shrouded contact points.
© Festo Didactic 8046444
®
may only be used:
Touch Panel TP700
21