Rampage 901004 Instrucciones De Instalación

For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-241-7219.
Contents
NOTE: Actual product may vary from illustration.
Header Channel
1
After removing the existing soft or hard
top, place the header channel with the
top installed above the windshield on the
gasket.
See Figure 1
2
Unbolt two Brackets from the Windshield Channel, insert them into slots on interior side of
windshield frame of Jeep, and bolt them back to the Windshield Channel. To assure a good
seal, apply firm pressure to the Windshield Channel toward the Jeep's front while bolting.
See Figure 2 and 3. Refer back to breif top installation instructions to complete.
Figure 3
Congratulations!
You have purchased one of the many quality Rampage branded products offered by Lund International. We take
the utmost pride in our products and want you to enjoy years of satisfaction from your investment. We have made
every effort to ensure that your product is top quality in terms of fit, durability, finish and ease of installation.
Installation Instructions
Windshield Header Channel
1997-2006 Jeep Wrangler TJ and
2004-2006 Jeep Wrangler Unlimited LJ
Clamp (x2)
800-241-7219 • Visit us at Rampageproducts.com
© 2018 Lund Motion Products, Inc. All rights reserved.
Rampage Products™ is a trademark of Lund Motion Products, Inc.
Bolt (x2) Washer (x2)
Figure 1
Figure 4
The material that your product is made from can
be recycled. Please also consider recycling the
packaging that your product came in.
Page 1 of 1
IS-901004_RevB
Tools Required
Ratchet with 1/2"
or 13mm socket