Costway HW67549DE Manual Del Usuario página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
6)Sedentary reminder
Press button "1"+ "3" at the same time, the hand controller displays "x.xh".
press"UP" or "DOWN"to set a specific time,such as 0.5h, it would exit automatically
after 2 seconds,the digital tube will goes out and display a flashing".", indicating it is
running for a specific time, when the buzzer prompts five times, the hand controller
would wake up automatically.
7)The internal parameters and installation height Settings
By pressing the "SET" key for 5 seconds,you can enter the setting interface, it
displays "S-x" and "x" flashes, where "x" is the parameter group. Press "SET" to
enter the parameter group and set the corresponding parameters. Press "UP" or
"DOWN" to switch the parameter group. After setting the parameters, press the
"SET" key and return to the running interface.
The parameters can be set as follows:
A. "S-1" 0 means metric display, 1 means inch display.
B. "S-2" means the accuracy of the sensor being blocked, 0 means off, 8 is the most
sensitive, and 1 is the least sensitive.
C. "S-3" means the accuracy of the upward current being blocked, 0 means off, 8 is the
most sensitive, and 1 is the least sensitive.
D. "S-4" means the accuracy of the downward current being blocked, 0 means off, 8 is
the most sensitive, and 1 is the least sensitive.
E. "S-5" means the installation distance at this time, the unit is cm.
F "S-6" 0 means loosening and stopping operation by pressing the storage location key,
1 means automatically running to the storage location by pressing the storage location
key, and stopping by pressing any key.
G."S-7" 0 means to close the 2-minute and 18-minute working system, relying solely on
the temperature protection controller. 1 means to open the 2-minute and 18-minute
working system.
H."S-8" means the tilt and sensitivity of the desktop. Prevent the inconsistent height of
the two table legs caused by the break of the screw rod or other reasons. 0 means off,
1-8 means an inclination angle of 0.5-4°.
12

Publicidad

Tabla de contenido
loading

Tabla de contenido