BaByliss I.Q 929 Manual Del Usuario página 6

All manuals and user guides at all-guides.com
To attach the cutting guide, first
adjust the cutting length to 3mm
and push on the guide until you
hear a 'click' . (Fig. 2)
To remove the cutting guide, first
adjust the cutting length to 15mm
or 30mm and push up on the
guide with your thumbs holding
both sides of the unit. (Fig. 3)
NOTE: The precision
is adjusted manually
independently of the graduated
screen.
TURNING ON AND USING
To adjust the trimmer's cutting
length, push the button (6) up or
down.
The length selected is displayed
by a LED:
- Red LED for lengths between 3
and 15mm
- Green LED for lengths between
18 and 30mm.
Switch the ON/OFF button.
You can change the cutting length
at any time.
CUTTING TECHNIQUES
ADVICE FROm THE EXpERTS
• Use the clipper on clean, dry
hair.
• To familiarize yourself with the
clipper, begin with the cutting
guide for a longer cut, then, if
you want a shorter cut, adjust
it by pushing the knob. You will
soon know the lengths of each
guide and each position.
• Always move the clipper against
the direction of hair growth.
• Begin at the nape. Place the
guide on the scalp and move the
clipper toward the crown of your
head. Move your clipper slowly,
pointing the teeth of the guide
slightly upward. Keep the clipper
in contact with your head at all
times. (Fig. 4)
• For the crown of the head, move
from front to back, that is, from
your forehead to the crown of
guide
your head.
and
• For the finishing touches, that is,
around the nape and sideburns,
use the clipper without a cutting
guide. Turn your clipper over
and move it from top to bottom.
(Fig. 5)
• If you want a length greater than
30 mm, or if you are experienced,
you can create 'comb' or 'finger'
cuts:
- Work without a cutting guide.
- Take up a small section of hair
with a comb or in your fingers.
- Move the comb or your fingers
along the section of hair to the
desired length.
- Cut your hair along the comb or
AND
your fingers.
- Remove the cut hair using a
comb and check the evenness of
the cut regularly. (Fig. 6)
Using the thinning guide
Switch the clipper to the 'THIN'
position. The thinning guide is in
front of the blades.
This technique allows you to thin
out hair to make styling easier.
6