Rs232 Pc Interface Capabilities; Download Suite Software Installation; Operation; Troubleshooting - Amprobe TR300 Manual De Uso

RS232 PC interface capabilities

The RS232 cable and the Download Suite software are required to transfer data to a pC. The
RS232 port is located on the right side of the instrument. There is an optional USb converter kit
(RS-USb) available for pCs with no available RS232 port.

Download Suite Software installation

insert the Download Suite CD into the CD-RoM drive.
To install the software, follow the on-screen instructions.

operation

1. open the program, double-click the Download Suite icon.
2. Click on work "with instrument" and then "next"
3. Select TR300 and click on "next"
4. Select program device and click on nexT . Click on nexT again to open the programming
screen (see figs 1&2)
5. Setup the parameters and click oK to start recording
6. To download file from the device, repeat steps 1 and 2. Select Download and click nexT.
(See fig.1)
7. Click nexT again to start downloading the file. Select the location where you want to store
the file and click nexT, YeS or no, and finiSH
8. Click on "Visualizations" to select digital meter, generic historical graph, or generic historical
table.(See fig.3)
9. Select the parameters you want to visualize and click oK.
nb. Refer to help menu for more details on how to use the Download Suite.

TRoUbLESHooTINg

Power on but no display or meter doesn't work .
• Check whether the DC power is connected or not.
• Make sure you press "START/STop" key for more than 0.1 Sec.
• Check the batteries and see if they make good contact and the polarity is correct.
• Replace the batteries and try again.
Error Codes.
• e02: The value is underflow.
• e03: The value is overflow.
• e04: wrong value is caused by e02 or e03.
• e11: RH calibration error. need to re-calibrate.
• e32: iC read/write error. Return the meter for repair.
• e33:Circuit error in measurement portion. Return the meter for repair.
11