Attach Handle - Uline H-3200 Instrucciones De Montaje

Figure 1
Figure 2
Figure 3
Figure 4
PAGE 2 OF 6
ASSEMBLY INSTRUCTIONS
Figure 2a
Frame
Frame
Reinforcements
Figure 3a
Round
Axle
Pin
1-800-295-5510
uline.com
NOTE: Do not use air or power tools.

ATTACH HANDLE

1. Slide handle into the top rails of frame. Align holes
in handle and frame. Insert four 6mm bolts through
the frame and handle and secure with locknuts.
(See Figure 1)
ATTACH NOSE PLATE AND AXLE SUPPORTS
1. Position frame reinforcements against bottom frame
rail. (See Figure 2a) Slide nose plate into channel
on frame reinforcement, keeping bolt holes aligned.
(See Figure 2)
2. Align axle support with outside rail of frame.
(See Figure 2)
3. Insert four 8mm bolts through the axle supports,
frame, frame reinforcements and nose plate. Secure
with locknuts but DO NOT tighten. (See Figure 2)
ATTACH AXLE AND WHEELS
1. Lay hand truck on front so axle supports face
upwards. (See Figure 3)
WARNING: If installing stair climber, refer to
instructions included with stair climber and skip
step 2. Once complete, continue with step 3. If
not installing stair climber, continue to step 2.
2. Insert axle through top holes in axle supports. Align
holes in axle with grooves on inside of the axle
supports. Use a hammer to tap in the round pins.
(See Figure 3a)
3. Slide a washer onto each end of the axle. Slide
a wheel onto each end of the axle. Slide another
washer onto each end of the axle. (See Figure 4)
4. Insert a cotter pin through the holes in each end
of the axle. Bend cotter pins using pliers to secure
wheels. Wheels should spin freely. (See Figure 4)
5. Tighten all lock nuts.
6. Check tire pressure (30 PSI max). Inflate if necessary.
0421 IH-3200