Mellerware Freezy! Manual Del Usuario página 8

ENGLISH
- Fix the two screws (3) at the bottom
of the crank.
Installing the fridge
- Before installing the refrigerator,
read all the safety instructions and
follow the instructions below.
- Put the refrigerator on a stable
and level fl oor, so that it makes less
noise. Make sure the fl oor is strong
enough to support your weight
when completely fi lled.
- If you were to put the refrigerator
on a carpet, place a wooden
board between the carpet and the
refrigerator. Be aware that placing
the refrigerator on a carpet may
cause the heat emitted by the
compressor to discolor the carpet.
- This appliance is designed to
be self standing and not to be
recessed or on a stand.
- Do not tilt the refrigerator more
than 45° when moving it.
- Avoid areas where the appliance
is exposed to sunlight, heat
sources (stoves, stoves, radiators,
etc.), extremely low ambient
temperatures or high humidity.
Installing it in the coolest area of
the room will save energy.
- ATTENTION: Do not apply force to
any part such as the condenser or
the door. The metal rails under the
refrigerator can have sharp edges,
so always unpack it carefully.
Do not drag the refrigerator, put
it carefully in its place to avoid
scratching the fl oor.
SPACE REQUIREMENTS
- Install the refrigerator so that you
have enough space to open the
door.
- Make sure that air can circulate
freely around the back of the
refrigerator so that the compressor
and condenser can cool down.
Leave at least 10 cm of space at
the back and 5 cm at the sides.
LEVELING
- The refrigerator must be level to
function properly. If it is not leveled
properly, the doors and magnetic
seal alignment will not be covered
properly.
- To level the refrigerator, adjust one
or both of the leveling feet on its
base.
EN