Eaton Cooper Lighting PORTFOLIO C4RV Instrucciones De Instalación página 2

Installation Instructions – C4RV/C6RV Commercial Recessed Compact Fluorescent Remodel
INSTALLATION
To Install Rough-In Section
1. Remove J-box arm from mount bar. (Figure 2.)
2. Insert J-Box into ceiling. Remove J-Box cover and
connect supply lead wires per wiring diagram
(Figure 4.) and in accordance with your local electrical
code(s) or NEC.
3. Insert Remodel ring into hole in ceiling by pinching
springs upward.
4. Reattach J-Box arm to mount bar. J-Box should rest on
ceiling. Tighten Screw. (Figure 3.)
Trim Installation
1. Insert trim into ring.
2. Align 2 screws in keyhole slots at the top of the vertical
reflector.
3. Tighten screws.
Figure 2.
2
J-Box
Mount
Bar
Installation Instructions - C4RV/C6RV Commercial Recessed Compact Fluorescent Remodel
705024INS
To Clean Trims
1. Gently wipe with soft, clean,dry lint-free cloth to
remove dust.
2. Wipe with mild detergent solution on a soft, clean cloth
to remove fingerprints and stains.
3. Rinse with clean water and dry with soft, clean, dry
lint-free cloth.
Figure 3.
RED
BLACK
WHITE
Figure 4. Wiring Diagram
ADP140610 www.eaton.com
Flex
Orientation
RED
BLUE
BLUE
BALLAST