Tally T2240/9 Instrucciones De Servicio página 8

Make sure that the unit is set to the correct voltage (i.e. 230 V
for Europe, 120 V for the USA). Refer to the type plate beside
the power inlet on the rear side of the printer.
If this is not the case, contact your dealer.
Never switch on the printer when it is not set to the
STOP
correct voltage since this could cause severe da-
mage.
Connect the power cable to the printer's power
inlet as shown in the figure.
Connect the power cable plug to a wall outlet.
Make sure that the printer and the computer are
STOP
switched off.
Connect the printer-end connector of the data
cable to the female interface connector and secure it with the
spring clips.
Connect the other end of the cable to the computer.
The power switch, which is used for switching the printer on
and off, is located at the right side of the printer.
witch
All manuals and user guides at all-guides.com
Quick start-up