GYS W5S - 4L Manual Del Usuario página 5

Thank you for your choice In order to get the maximum profit of your product, please read with care the following
instructions: The W5S-4L is a wire feeder suitable for a water or air cooled torch and designed for use with MIG
450 WS, 450 GR et 350 GR. The wire feeder works with 200mm reels.
PRESENTATION
1 For 200mm Wire Reel
2 Wire feeder
3 Handle
4 Wire speed potentiometer
5 Euro torch connector
ASSEMBLY AND CONNECTION (I AND II)
• Gas connection :
Fit the gas pipe to the connector 6 of the wire feeder (collar included).
• Contact Cable Connection :
Connect the connection cable between the wire feeder and the generator, making sure that the power connectors
8 & 11, the command connectors 7 & 12, and the water connectors 13 & 9 (13 and 9 only for the 450 WS) are
securely tightened.
WIRE REEL INSTALLATION (III)
• Open the door of the machine.
• Remove the supporting screw 3
• Position the reel on to the support 1 . respect the pin..
• Adjust the break 2, to avoid reel movement and thus tangling the wire when welding stops.
• Put the supporting screw 3 in position and tighten it by hand.
• First use:
-Release the fixing screw of the wire guide 4
-Put the rollers 5 in place. The visible diameter on the roller should be the actual wire diameter used.
-Place the wire guide 6 as close as possible to the roller but without touching it, then tighten the fixing screw.
• To adjust the drive rollers: loosen the drive roller knob as far as possible 7, insert the wire until it exits the other
side by about 2cm then close the door. Start the motor by pressing the torch trigger. Press the trigger to feed the
wire and progressively tighten the knob. The setting is correct when the guide roller slides over the wire, even
when it is blocked at the end of the torch.
USE
These wire feeders allow the user to weld using the parameters set on the generator. To adjust the settings to the
type and diameter of wire used, please refer to the MIG 450 WS, 450 GR or 350 GR user manual. It is possible to
change the wire speed in synergic or manual mode using the potentiometer on the front panel.
DUTY CYCLE
All manuals and user guides at all-guides.com
6
7
8
9
W5S - 4L
W5S-4 L
Gas connector of the connecting harness
Control cable connector
Power cable connector
Water connection
I2 max 60%
450A @ 50% 410A
5
100%
320A
EN