Price Pfister Skye 42 Manual Del Usuario página 3

7
7A
7B
7C
7 SECURING SPOUT BODY
From underneath sink, secure Faucet Body (7A) by placing Metal Washer (7B) and
7
threading Long Nut ( / Hex.) (7C) onto Mounting Post (7D). Make sure that the bumps
16
on Metal Washer (7B) are facing up. Firmly hand tighten Long Nut (7C). Secure Long
1
Nut (7C) not to exceed a / turn.
4
Caution: Do not over tighten!
8
8A
8D
8B
8C
HOT
8 WATER SUPPLY CONNECTIONS
Gently separate hot and cold supply tubes (8A), approximately three inches apart.
Connect water Supply Lines (8C) to Faucet Inlets (8B). Hot water supply line goes to hot
inlet fitting indicated by red tag (8D). (Supply lines not included). Follow manufacturer's
instructions when installing supply lines.
ENGLISH
7D
8A
8B
8C
COLD
9
9 POP-UP ROD CONNECTION
Insert Pop-Up Rod (9A) on the back of Spout head (9B). Gently, slide Pop-Up Rod (9A)
down the Spout Head hole (9B)
DRAIN BODY INSTALLATION
10
10A
10 POP-UP INSTALLATION
Install and adjust Pop-Up (10A) using separate instructions supplied with the Pop-Up
assembly.
11
11 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
3
9A
9B