Accessories/Replacement Parts - Craftsman WEEDWACKER 316.790130 Manual Del Usuario

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

2. Remove the Bump Knob, foam seal, spring, reel,

and trimming line from the reel housing (Fig. 21).

3. Remove any debris or grass from the knob, spring,

reel, and foam seal. Remove any existing line from

the reel before cleaning. Wash the reel with warm

soapy water (Fig. 22).

NOTE: The reel must be completely dry before

reinstalling it into the reel housing. Do not lubricate the

reel or reel housing assembly.

4. Clean the shaft and the inner surface of the reel

housing. To clean the shaft underneath the plunger,

press down on the plunger (Fig. 23). Remove any dirt

and/or debris from the shaft.

5. Install the reel, spring, foam seal, and Bump Knob

into the reel housing (Fig. 21).

6. Tighten the Bump Knob clockwise.

7. Install new line as described on pages 12 and 13.

Installing a Prewound Reel

1. Insert the ends of the two trimming lines into the

eyelets in the reel housing (Fig. 24), then grasp the

ends and pull firmly to release the line from the

holding slots in the reel.

2. Hold the reel in place and install the Bump Knob,

spring and foam seal in the counterclockwise

direction. Line installation is now complete.

Reel

Spring

Foam Seal

Bump Knob

Fig. 21

Reel

Fig. 22

STORING THE UNIT

Clean the unit thoroughly before storing it. Store the unit

in a dry, well-ventilated area, locked-up or up high, out

of the reach of children.