Indesit UI6 F1T W1 Manual De Instrucciones

Quick guide
THANK YOU FOR BUYING AN INDESIT PRODUCT
In order to receive a more complete assistance, please
register your product on
PRODUCT DESCRIPTION
FIRST TIME USE
Wait at least two hours, after the installation, before connecting the
appliance to the power supply.
Connect the appliance to the power supply and turn the thermostat
knob to switch on the appliance.
CONTROL PANEL
TEMPERATURE ALARM INDICATOR
When the product is plugged in to the mains, during the first 10
minutes of working, any temperature sensor failure will be displayed
on the control panel.
The appliance will work anyway preserving the food stored, but it is
necessary to contact after-sales service and provide alarm code.
Note: The Temperature alarm may activate if the door is left open for a
prolonged period of time or following the introduction of fresh food in the
freezer compartment; this temporary rise in temperature does not affect
the storage of already frozen food in any way.
FAST FREEZING FUNCTION
The use of this function is recommended to increase the cooling speed
when placing a very high quantity of food in the freezer compartment.
To activate this function press the Temperature button on the control
panel repeatedly until 3 LED's flash and then remain lit.
The function is automatically deactivated after 48 h.
www . indesit . com/ register
2. 3.
1.
Legend: Led ON Led flashing Led OFF
Before using the appliance carefully read the Safety
Instruction.
After turning the appliance on, you must wait for 4-6 hours for the
correct storage temperature to be reached for a normally filled
appliance. Position the antibacterial anti-odour filter in the fan as
demonstrated in the filter packaging (if available).
1.
2.
3.
TEMPERATURE SETTING
Press the Temperature button on the control panel to adjust the
temperature from the warmest through the lower to the coldest level.
Pressing the Temperature button, the temperature setting will change
cyclically.
At first plug-in of appliance temperature setpoint is present at medium
position (factory setting).
Following table shows temperature setpoints:
high temp.
med-high temp.
medium temp.
med-low temp.
low temp.
Led ON Led OFF
Led ON Led OFF
Note: Displayed set points correspond to the average temperature
throughout the whole freezer.
STAND-BY BUTTON
To put the product in Stand-by, press and hold for 3 seconds the Stand-
by button. All the indicators turn off. To reactivate the appliance press
once (briefly) or for 3 seconds this button.
Temperature alarm indicator
Fast freezing function
Temperature settings
(stand by button)
EN