How To Install - GOAL ZERO YETI LINK Guia Del Usuario

Ocultar thumbs Ver también para YETI LINK:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
Back of Link Expansion module
EC8 External Battery
Connector
Ensure cable is fully inserted and tightly in place before use. Check
upon subsequent uses. For questions, contact Solutions Center at
support@goalzero.com or 1-888-794-6250
3
Fan Vent

HOW TO INSTALL

Tools you'll need: Phillips Screwdriver
1. Turn off all the output ports and unplug the Yeti from any power
source.
2. Open the lid of the Yeti and remove the expansion module carriage
from the Yeti by removing the six screws and sliding out the
carriage.
3. Insert the included Link Lock into the opening facing the back of
the Yeti and line up the screw holes on the Link Lock with the holes
on the Yeti.
4. Take the blue connector and micro -USB cable on the Link module and
insert them into the module and micro-USB ports on the Yeti, matching
positive to positive, negative to negative, and micro to micro.
4

Publicidad

Tabla de contenido
loading

Tabla de contenido