How It Works - Vehicle Mode - GOAL ZERO YETI LINK Guia Del Usuario

HOW IT WORKS - VEHICLE MODE

Quickly and easily recharge a Yeti Lithium (1000 or higher) from your vehicle
while on the move. Charge rates vary from 25A - 80A Max Current (300W -
750W) depending on Yeti Lithium size and capacity.
Goal Zero
Solar Panels
(Sold Separately)
How it Works
When placed in "Vehicle Mode," the Yeti Link allows your Yeti Lithium to safely
pull power from your vehicle's alternator while the vehicle is running and stop
pulling power when the vehicle is off.
NOTE: Yeti Link must be in Vehicle Mode to utilize this feature or it will drain
your vehicle's battery. All Links come standard set in "Tank Mode."
Once Link is installed in Yeti, switch Link from Tank Mode to Vehicle
1.
Mode by pushing the pinhole reset button on top of the Link four times.
Indicator lights will turn on and blink together when the Link is
2.
successfully placed in Vehicle Mode.
To switch back to Tank Mode, press pinhole reset button on top of the
3.
Link four more times. Indicator lights will scroll from bottom to top
individually when the Link is successfully placed in Tank Mode. NOTE:
Do NOT place back in Tank Mode while connected to your vehicle.
Pinhole Reset Button
11
Goal Zero Yeti Lithium and Goal Zero Yeti Tank
Goal Zero Yeti Link Expansion Module Expansion Battery
+
REQUIRED (sold separately) (sold separately)
EC8 External
Battery Cable
Once Link is switched to Vehicle mode you will be able to connect to
4.
your vehicles +/-battery or alternator. By using the Goal Zero EC8
Extension Cable.
Note: only use authentic Goal Zero cables to do this.
DO NOT use more than one Extension Cable
DO NOT have a secondary battery in between the Link Module
and the vehicle alternator or main battery
Connect the Ring Terminal Cable to the positive and negative terminals
5.
on the either the main battery or the alternator.
Improper connections will damage the Yeti Link Module/Accessory
6.
cables and/or cause serious injury or death. Be sure that all wiring is
connected to the appropriate polarity
Plug the Male end of the EC8 Ring Terminal cable into the Female end of
7.
the EC8 Extension cable.
Plug male end of Extension Cable into the External EC8 port of the Link
8.
Module and slide either the straight or the 90-degree EC8 cable holder
over the cable and into the slots of the Link Lock.
Make sure cables are securely connected. Check cables
•
periodically especially before and after uneven roadways.
WARNING: Ensure that you only use Goal Zero products between
your Link and Alternator. Any other cables or wiring is not
supported or recommended as these cables need to be rated to
carry a minimum of 80A Max Current
Ensure cable is fully inserted and tightly in place before use.
Check upon subsequent uses. For questions, contact Solutions
Center at support@goalzero.com or 1-888-794-6250
or
12