Twin-Star International 18DF2433 Instrucciones De Ensamblado página 8

9. Insert one Wood Dowel (CC) into each of the
pre-drilled holes on the top edges of the Assembly
from step 8. Then locate Mantel/Top (G) and lay
fi nished side up on top of completed assembly.
From the inside, attach Mantel/Top (G) using Bolts
(AA) and Washers (BB) through the pre-drilled holes
in the mounting blocks.
HAND TIGHTEN ONLY.
Using Phillips head screwdriver tighten all Bolts
alternating top and bottom, left and right.
Hardware Used
AA Bolt
BB
Washer
CC Wood Dowel
10. Locate Front Doors (L). Slide door hinge keyhole
into panel hinge bracket. (Diagram 1)
Use Phillips Head Screwdriver to tighten screws.
(Diagram 2)
TO ADJUST HINGES
To adjust door forward or backward change
keyhole slot position. (As Shown In Diagram 3a)
To adjust door right or left loosen/tighten screw.
(As Shown In Diagram 3b)
To adjust door up or down adjust bracket height.
(As Shown In Diagram 3c)
Attach the Knob (FF) to the Front Doors (L), use
the bolts attached through the pre-drilled holes in
the doors. Then use a Phillips Head Screwdriver to
tighten the bolts.
Hardware Used
FF Knob (with bolt)
11. Choose desired height of Shelf (K) and place the
four Shelf Pin (GG) into same height shelf holes
inside side panels. Insert Wood Shelf (K), allow
Wood Shelf (K) to rest on the Shelf Pin (GG).
Hardware Used
GG Shelf Pin
All manuals and user guides at all-guides.com
x 6
x 6
x 8
x 2
x 8
7
Fig. 9
G
CC
BB
AA
Fig. 10
L
Fig. 11
FF
K
GG