Starting The Dishwasher - Ariston LL 64 B NA Manual De Uso Y Cuidado

Starting the dishwasher

Ready, steady, go!
You have loaded your dishes and you now have to set
the wash cycle. It takes just one minute to learn how
After performing all the
operations described in
the previous paragraphs
press on-off button "A":
indicator light "B" comes
on.
Selecting the wash cycle.
To select the wash cycle
press button "P". Each time
you press the button, a
beep will sound and
indicator lights "E" will light
up in sequence: choose the
cycle you deem most
suited to the type of dishes
to be washed (have a look
at the wash cycle table on
page 7). If the appliance
door is shut, press the Start
button "R" and you will hear
a beep; the cycle will start
up within a few seconds.
The dishwasher keeps you
informed.
Your dishwasher is fitted
with indicator lights (G)
which light up to indicate
the cycle phase under way.
prewash,wash,rinsing,
drying. At all times, your
dishwasher tells you which
cycle phase is under way.
Modifying a wash cycle in
progress.
If you have chosen the
wrong cycle, not to worry!
You can modify the wash
cycle in progress, if it has
only just started.
Keep the RESET button
"R" pressed for about 5
seconds: a prolonged beep
will sound, followed by
three short beeps. Indicator
light "G" will turn off and at
this stage, all the settings
will have been cancelled.
You are now free to re-set
the correct wash cycle.
You can cancel the
wash cycle in progress,
if it has only just started.
www.aristonappliances.us
All manuals and user guides at all-guides.com
You've left out a dish?
Well, it happens to
everyone.Interrupt the
wash cycle by pressing the
ON-OFF button, insert the
dish you had forgotten
and press the ON-OFF
button again. The cycle will
start up from where you
interrupted it.
Finished?
The end of the wash cycle
is indicated by two short
beeps and the flashing of
the drying phase indicator
light.
Warning:
Press the ON-OFF button
as well, thus cutting off the
electricity supply to the
appliance., unplug the
appliance from the
electricity socket to cut off
the power supply; the
power supply cable should
consequently be easily
accessible.
• If accessible turn off the
water tap.
• Wait a few minutes
before unloading
the dishes: they are very
hot! If you wait a little while,
they dry better thanks to
the steam.
Empty the lower rack
first.
If opening the
door soon
after the end
of the program, or
during it, stand away
from the dishwasher,
to avoid possible
injury from hot steam.
There's been a power failure?
Have you opened the
dishwasher door?
The wash cycle stops and
then restarts when the
electricity comes back on
or when you shut the door.
Everything is under
control!
ARISTON DISHWASHER - User Manual 5
Would you like to see
which settings you have
made?
At any time, when the cycle
is under way, if you press
button "P", the cycle in
progress indicator light will
light up for a few seconds.
Make sure the wash
cycle has ended before
removing the dishes!