Uline H-7883 Manual Del Usuario página 2

3. Set dispenser aside and drill into wall at four marked
locations with an appropriate drill bit. (See Figure 3)
Insert wall anchors if necessary.
4. Hold dispenser to wall so holes in dispenser align
with previously drilled holes in wall. Insert four screws.
LOADING THE DISPENSER WITHOUT A STUB ROLL
1. Open cover and load paper roll with paper "tail"
unwinding from back of roll. Place paper "tail" over
the back transfer bar arm and under the front
transfer bar arm. (See Figure 4)
2. Firmly close dispenser. The unit is ready to dispense
at the factory set nominal 11-inch paper length (it
takes about three dispenses to self-adjust to the
nominal paper length). (See Figure 4)
Figure 4
Transfer
LOADING THE DISPENSER WITH A STUB ROLL
1. When the main roll is approximately 2.6" in diameter
(60' remaining), move the stub roll to the lower roll
holders. (See Figure 5)
Figure 5
PAGE 2 OF 9
MOUNTING CONTINUED
Bar
Figure 3
LOADING
2. Lift the transfer bar and place the paper under both
the front and back arms. The paper should dispense
between the two white rollers.
3. Load the new towel roll into the upper roll holders so that
the paper feeds down from the back. (See Figure 6)
Figure 6
4. Lift the transfer bar and place the leading edge of
the new paper roll under the front transfer bar arm
and on top of the existing paper sheet. Release the
transfer bar. (See Figure 7)
Figure 7
5. Leave some slack in the main roll to ensure proper
transfer.
0721 IH-7883